Influence of Plastic Modular Belt Production Process On Product Life

1: For example, if there is a phenomenon of running the film on the Plastic Modular Belt, adjust the tensioning shaft at one end of the moving shaft, and adjust it slowly. Remember to adjust it quickly to avoid scratching the edge of the mesh belt.

2: If the mesh belt has a phenomenon of jitter, check whether the rollers in the conveyor frame and the conveying tunnel are rust-free and refuse to turn, and adjust them one by one.

3: If the chain transmission mesh belt has a jump chain, the operation is unstable, check whether the sprocket at both ends of the drive shaft is synchronized, and whether the top of the tooth is excessively worn.

Main factors affecting the life of the Flat Top Conveyor Belt:

1, mesh belt material (original Japanese material life expectancy)

2. The furnace use of the mesh belt is quenching or carburizing, and the carburizing life will be relatively short.

3, the use of quenching medium, the general salt bath network belt has a short service life

4, the design of the equipment itself, the equipment is mechanically problematic

The structure of the conveyor belt: the ordinary mesh belt is composed of two kinds of mesh surface and shaft, and the other one with chain is composed of three types: chain, support shaft and mesh belt.

Conveyor belt production process: the equipment mainly consists of entanglement machine, embossing machine and argon arc welding. The thickness of the ready-made materials is different. The thickness of the general mesh belt and the mesh belt shaft are different. The current pressure shaft is measured according to the width of the mesh belt. It can be wrapped around the wire. This can be produced at the same time. After the two come out, they are assembled by the workers. The two sides are spot welded. The finished product is ready.